Wednesday, September 19, 2012

Let's Hear It For The Girls! Renfrew Top Muslin

So in my last post, I successfully tackled my very first FBA.

Here it is again in case you missed and needed to marvel in its glory again:

It's full...and it's busty...

I cut the largest size (16) based on my high bust measurement, but also traced the lines of the size 14 as around the hips and waist they matched better.

But what did the thing I made with it look like? I hear you cry:

Mmmmm...shiny...

As you can see, I didn't finish this top off completely (check out the left sleeve compared to the right...).  There were two reasons for this - most importantly, it is a muslin and I don't totally love the shininess of the fabric.  The second reason will become clear later.

When I first tried it on I was quite happy with the fit (I would buy a top from a shop that fitted me like this) but on closer examination, I became less happy.  Here it is from the side:



There is definitely too much pulling from underneath the bust all the way under the arm and down to the small of the back.  It also sits a bit higher at the front than the back, which makes me suspect the FBA might not have been full enough.

On lifting up the arm, it is seriously evident that the armscye is rather too small.  It could be part of the fit of the top but I think it's more likely to be to do with the FBA and to be something I should aim to rectify.


I also think I need more room through the back, though from this picture it doesn't look as much like that as it feels.  In fact this picture shows some odd baggyness in the lower back which I wasn't really aware of until I looked this picture.  


You can definitely see the pulling around the arms in the shot above (and while the smallness through the back isn't evident it's definitely noticeable by feel).  The arm pulling thing can be seen a bit again below too:


And again with the small armholes.


So in summary.

I like the pattern, it's easy to follow.  I like the cuffs, waistband and way of doing the neckline.  When I get it right I will probably make several of these a year with variations.
I need to add some ease to the back, lower the armscye and also make the armscye a bit bigger.  I also need to gather in the ease in the sleeves (if there is any after the armscye gets bigger) when setting them in.  I didn't do that and some of the pulling is inexpert / lazy sleeve sewing (trust me...).

Finally (and the other reason this is only going to be a muslin):  I need to not accidentally snip holes in the fabric of the top when trying to trim the inside of the neckline attachment in not one, but TWO different places.


Not as super obvious in the pictures, particularly due to world's shiniest fabric, but rather obvious in real life...



Oops!

Overall not a bad first FBA experience and a good demonstration of a reason to muslin.  I would have been more than a little disappointed if I had gone to the effort of making a muslin and found no fitting adjustments to make :)

Next version will be short sleeves / no sleeves and black (coming into spring here but black always works!).

Friday, September 14, 2012

Let's Hear It For The Girls! My first FBA...

Let's hear it for the girls!

Not the small people girls, but The Girls, girls!

Or really; let's not hear it for The Girls because frankly, they make my life harder.  They don't fit into most fitted shirts or dresses.  Those they do fit into, while still fitting my waist, look a bit obscene.  Buying a bra means I have to remortgage the house.  In short, big boobies are a PAIN (in the back).



However.  The older I get, the happier I am with my body.  The Girls have seen me through thick and thin (some might say, mostly thick).  The Girls fed my babies.  Until my husband met me, he wasn't really a big boob kind of guy (am just assuming he is now hahaha!).  If there's a thing that I manage to pull off, it's being bigger in many ways (I am at least 6 foot tall, have size 11 feet and frankly, am kind of forceful of personality...) and The Girls are all part of that.

So what is a girl with Girls to do?  I can do what I have always done; buy whatever fits me (and sadly, sometimes things that don't but that I reeeeeally reeeally want to) and get by.  Or maybe;  I could make things for me.  Fitted for me.  Tailored for me.

To do this implies a lot.  It implies that I have the skills.  I think I do, but it's a scary assumption without any real doing yet.  It implies that things I make will look nicer if I fit them to me.  I hope so.  It implies I am worth the time and the effort and the fabric.  It changes (or will change) the way I sew.  I don't really make muslins or fit stuff properly because cutting and stitching is scary fabric carnage which can't just be thrown away.  Actually on that subject, I still plan to make wearable muslins because I am so time poor that I just can't bring myself to sew fully throw-away garments.

So here is step one.  This is the Sewaholic Renfrew top (v-neck and long sleved).  With.........wait for it........full bust adjustment!  Yes!  FBA!  Step One!


Step One:  Deciding to do an FBA

This was my biggest leap, mentally.  Not because I didn't think I needed one, but because I didn't know where to start.  In fact, I was making a stretch fabric top (the much celebrated Renfrew from Sewaholic patterns) and I didn't even know if an FBA was a thing you did for stretch tops.  *Hangs head in shame*.  Google confirmed it was, and I set to work working out what to do.

The Renfrew is NOT my shape, according to the measurements.  The size 16 was too small in the bust (by several inches), OK for the waist and way way way too large for the hips (like 6 inches too large!).   So what size do I cut?  If the pattern went to larger sizes my problem would have been even worse (by the time we reached my bust size the hips would have been nearly 10 inches out, assuming consistent scaling).  However, various tutorials mentioned to aim for the size closest to your high bust measurement when doing an FBA.  So if my high bust is 40, that puts me squarely in between size 14 and a size 16.  Given the waist was OK at size 16, I cut a size 16 with an FBA and planned to do some grading down in the hip area.

Step Two:  Cutting out the pattern

This isn't really hard...but here it is:
  1. Identify pieces needed - I was making view B (v-neck) with the sleeves of view A (long, because it's winter/spring here)
  2. Iron pattern pieces and pattern trace stuff (every time I skip this step I regret it)
  3. Trace around patterns at the size 16 and also the size 14 lines, including markings.  This is because I planned to grade the hip area of the top down to at least the size 14, if not further, based on measurements.  Having the size down marks will help to see where those lines might go.  I have done various pattern grading things before, but mostly for kids clothes where the lines tend to be parallel all the way around the pattern piece (i.e. size 4 might be universally 1/2 inch more than size 3 or whatever).  "Grown up" patterns don't work that way - there might be an inch difference at the bottom but only a quarter inch at the waist (for example).

Step Three:  Alter the pattern for length

I hadn't even thought about this bit until I traced the pattern and it had the usual "lengthen or shorten here" marks!  I am tall but most of the unusual length appears to be in the legs, so I am not going to add any length to this one.  The stated 25.5 inches comes from the back of my neck to well down on my hips (where the front of my hip bones sit I guess), which seems like enough.  If it isn't, I could add length to the waistband piece which will hopefully look OK slightly longer.

Step Four:  Alter the pattern for the hips

As noted above, the hip measurement for the size 16 is 47 inches, which is substantially larger than my hips. They are apparently still a bit smaller than a size 12 (43 inches) according to the measurement given (seems decidedly unlikely).  However the pattern finish size for the hem (which is going to sit roughly around my hips) is 45 inches for the size 16 and 43 inches for the size 14.  Am guessing the extra bulk of the folded hem makes this area firmer and smaller than you might otherwise expect.  So for caution's sake, I planned to grade down only to the size 14, with the caveat that I might just take a bit more out when sewing it if I try it on and it's swimming around me.

Step Five:  Alter the pattern for FBA

The Final Frontier!



I Used Other People's Tutorials for Actually Doing The FBA:


Sew L.A.  - probably my favourite tutorial, though there are many, and I checked many out before I cut up the pattern.  Steps you through this super well, with clear pictures and details.   I had planned to doco what I did, but frankly this is pretty much what I followed and these are the results:

I found this to be, super easy.


The Only Other Things:

Aside from the booby inclusion, there are other things that need to be thought through.  The changes to the pattern will affect the length at some places (which I chose to ignore / remove), but which might be worth keeping and including in the other pieces if you are long in the body.  There are multiple tutorials which include doing this for patterns with bust darts and similar, which are very necessary if the original pattern has more structured accommodation for the laydeez.

The Other, Other Things:

Also, for those of you who wondered why I was a bit quiet in the last few weeks...



It snowed!  (up the mountain).  I had to go play in it with my Australian babies, who won't see as much of this stuff as I have :)